Instruktsiia Po Ustanovki Dveri Kupe Access

Installing sliding "coupe" doors (whether for a wardrobe or as an interior room divider) is a manageable DIY project that focuses on precise measurements and level tracks. 1. Preparatory Measurements Before installation, verify your opening dimensions.

Angle the top into the rear groove of the upper track, then lower the bottom rollers into the rear groove of the bottom track. Repeat the process for the . 4. Final Adjustments instruktsiia po ustanovki dveri kupe

: Use a level or plumb line to ensure the side walls and floor are perfectly horizontal and vertical. Installing sliding "coupe" doors (whether for a wardrobe

Lift the (the one further inside the closet) first. Angle the top into the rear groove of

For , align the lower track with the top one using a level or plumb line.

: Turning these screws clockwise or counter-clockwise will raise or lower that side of the door to make it plumb.

: If your kit includes stoppers or soft-close mechanisms, slide them into the top track and tighten them at the points where the doors should stop. Recommended Tools Level and tape measure Drill with pilot bits Hacksaw (to trim tracks) Screwdriver (for adjustment screws) Installing a Sliding Closet Door Track